2006 hawkeye scoob induction kit

[scotonarock]

Hi just wondering if any of you have any opinions on what induction kit to fit the above??
some say the K&N but i am sure i have read that they are no good on scoobs or are they all a much of a muchness??

[Dooahhdoo]

People in the know said not to run an induction kit on earlier scoobs due to the vibration on the MAF which damages it but I ran a K&N cone filter on my STI for the 7 years I owned her. It did start running lumpy towards the end of ownership though and the dealer I sold it to said he replaced the MAF and all was good. Not sure about the later models but if you dont get a good answer here try http://www.sidc.co.ukâ™ 

[Straightsix]

I personally wouldnt use K&n the way the cone is it makes a whisliling noise as the air passes through it making it the most anynnoying induction kit ever.
Also the filters are often over oiled and kill your maf sensor
After looking around ive decided to get an AEM one for my car as all you hear about them is praise. should be here today with a bit of luck

[scotonarock]

Thanks to both of you for your response.
I have just bought it and looking to do a couple of mids nothing serious.
I knew i had read it some where about the K&N Dooahhdoo. just couldnt quite remember in what capacity..
Straightsix you must tell me how you get on with your AEM!
I will have a look at all types i think i may not bother as yet but soon though just doing a bit of research!!